Bronco Forum - Full Size Ford Bronco Forum banner
1 - 1 of 1 Posts

Man of endless projects
9,644 Posts
Discussion Starter · #1 ·
Selling a Dana 50 third member. it has 5.13 gears and a Yukon Grizzly locker. gears are in good condition, will have new bearings and seals. has a drain plug drilled and tapped. will swap into a D44 TTB while being stronger

old picture, will post new picture once new bearings installed

had it in my 88 for a few years (4-5 outings only). did a D60 SAS and wont be needing it anymore. asking $800 local pickup. could possibly ship but it would probably be about $150 more. located in Palm Harbor, FL near Tampa Bay area

also have a driver side chromoly axle shaft assembly (inner, outter and u-joint) to go with it if desired. do not have passenger side. u-joint is a Spicer 5-760X with full circle snap rings. its dirty but perfectly fine. $100.

1 - 1 of 1 Posts