Bronco Forum - Full Size Ford Bronco Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
559 Posts
Discussion Starter #1
Was cruising around Wal-Mart this morning and they had CH 7 gal tanks w a gauge for $20, 125psi gauge for $11, oil filter for $12, plus tons of misc fittings and whatnot on the cheap.. what did everyone use for manifolds?? just need to get a pressure switch from HD and will be good to go..
 

·
Some assembly required!
Joined
·
5,402 Posts
I don't think you'll find the pressure switch you need at Home Depot, the ones they carry are for wells and cut of at about 50 pounds. I don't think they carry a compressor one.
 

·
Some assembly required!
Joined
·
5,402 Posts
I was at HD today and took a look at their pressure switches, sure eenough, no compressor switch. You can definitely get one at Grainger, and I bet Northern Tool would carry one.
 

·
Registered
Joined
·
559 Posts
Discussion Starter #5
yeah, i looked on their web site and they didnt have one listed.. im going to call around a bit and check with the local welding supply and gas supply places..
 
1 - 5 of 5 Posts
Top