Bronco Forum - Full Size Ford Bronco Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Have used these forums for earlier repairs, but newly registered. Looking to replace the u-joints and the front axle drive shaft on my 96. Can anyone give some insight as to wether or not the knuckle needs to be disassemled to remove the driveshaft or will it just slide out when the hub is taken apart? Any diagrams of assemby would be greatly appreciated.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top