Bronco Forum - Full Size Ford Bronco Forum banner
1 - 1 of 1 Posts

·
Charlie don't surf..
'92 Ford Bronco XLT
Joined
·
16,523 Posts
Alan, my spindle bearing was shot on the driver's side as well. I'm not sure if that resulted in my dirver's side hub going out on several occasions, but since I replaced that spindle I havn't had any problems. Wished I new you could just replace the bearing in the spindle it would have made life a lot easier. I'm with Zach on the dust sheild. Cut around it to where it mounts behind the spindle to keep the dimensions and tolerances the same.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top