Bronco Forum - Full Size Ford Bronco Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
13,891 Posts
just stick a new bearing in the spindle and call it good. it will be okay if it slops aorund some. just make shure the shaft doesn thave any burs on it, grease it up and stick it back toghther.
remeber, your going to tear it all apart again after you go in deep water anyways....
as for the dust sheilds. around here they fall off on there own.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top