Bronco Forum - Full Size Ford Bronco Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
I have aquired a fuel tank, sending unit, and connector off of a 92 F150 and a 96 F250 PSD. I was wondering if anyone knew the sending unit resistance on these two models and an 86 Bronco. This way I can determine which one I would be easier to swap into my Bronco without having to do a gauge swap also.
Thanks,
Byron
 

·
Registered
Joined
·
2,689 Posts
Hey byron
Glad to see you made your way over here. Welcome to your 2nd home. I would think that the Bronco and the F-150 would be about the same. Will the one from the PSD even work since it was diesel.
 

·
Administrator
Joined
·
22,838 Posts
Hey byron
Glad to see you made your way over here. Welcome to your 2nd home. I would think that the Bronco and the F-150 would be about the same. Will the one from the PSD even work since it was diesel.
incorrect....I know when I installed the 92 fuel tank in my 85 I had to get a a/m gas gauge due to the ohms being different...call autometer they can tell you the different ratings.
 

·
Registered
Joined
·
2,689 Posts
Well now i have been taught something.

Thanks Tim.
 

·
Registered
Joined
·
1,573 Posts
IIRC between 86 and 92 the way the fuel gauge reads got reversed. 86 grounds to full and 92 should ground to empty.

Justin
 
1 - 7 of 7 Posts
Top