Bronco Forum - Full Size Ford Bronco Forum banner

1 - 4 of 4 Posts

Registered
Joined
1 Posts
Discussion Starter #1
If you live near Wichita Kansas (or want to travel here) I have a hard top and gasket that came off of an '80 or '81 Ford Bronco. It is in good shape, all of the glass is in tact. It was taken off several years ago because I had a soft top made for it. It has been sitting in my back yard for years and the wife finally told me to get rid of it. I would just take it to the dump, but I would rather see someone else get some use out of it. I can send pictures if you want any.

Thanx,

Bob
 

Premium 4 Lyfe - Way Back Staff
'95 XLT: 5.8, MAF, E4OD, 4.56's, 6" on 33's
Joined
37,576 Posts
Hey Bob... any chance of you trimming and sending parts of this top?

I'm researching building a soft-top and a set of top rails sure would be nice.

I'll cover shipping, if you can cut me about 1 inch up from the bottom (basically the rear window bottom) all the way around, then cut (center of corner areas) box and send.

:shrug
:thumbup
 

Registered
Joined
156 Posts
Hey pepe if i make it through the winter with just my soft top ill be intrested in getting rid of my hard top

Just informing you of course

I figured since were in the same state i could help you out

Matt-- :thumbup
 

Premium 4 Lyfe - Way Back Staff
'95 XLT: 5.8, MAF, E4OD, 4.56's, 6" on 33's
Joined
37,576 Posts
That would rock Matt.
I'm looking for materials to get the SoftTop prototype goin' so I'll take what yer willing to let go, whenever yer ready! :thumbup
 
1 - 4 of 4 Posts
Top