[meatbullet4264]

can any one recommend headers for my 78? i want something thats gonna fit well and not a pain in the ass to put in.i found some flow-techs for $135.00 which are supposed to fit. any thoughts?

 

[J&SBroncolvrs]

they are easy to fit in but it's hard to get over the crossmember with the exhaust pipes. easier if you are doing a single exhaust and not dual.

 

[meatbullet4264]

i'll be doing a dual. any extra parts i may need?thanx for the insight.

 

[highhorse78]

Check out this thread where I have a bunch of pics showing how I routed my exhaust using Dynomax headers-
http://fullsizebronco.com/forum/showthread.php?t=124071&highlight=dynomax

 

[J&SBroncolvrs]

if they are the same as the flowtechs I have the drivers side one comes down on the left side of the front drive shaft (looking from the front). The crossmember is about in the middle of the headers, so sharp angle will be needed to get up over the crossmember. I just stuck my old exhaust on under the crossmember for now until I can afford good stuff