Bronco Forum - Full Size Ford Bronco Forum banner
1 - 2 of 2 Posts

· Registered
5 Posts
Discussion Starter · #1 ·
i have a 89 with a 351 engin my heater fan runs but not enough air comes out the vents when i put the heat on it doesn't blow out hard at all but i can feel the warm air its the same when i switch over to the air conditioner. i read some of the posts last night about heater problems i took the resistor off buy i can't tell if its bad i cleaned out some leaves that were in side the heater but still no changing of speed in the fan any ideas thanks, geo
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.