Bronco Forum - Full Size Ford Bronco Forum banner

hey i need some bearing help.

598 Views 6 Replies 5 Participants Last post by  waltman
alright, so i took off my hub and rotor and switched vout the rotors and im ready to put them back on. where and how does this bearing go back on? does it go in after the rotor and hub or before the rotor and hub? and in which direction?
See less See more
1 - 2 of 7 Posts
looks like the outer goes in before the large round nuts go on. but did you regrease or replace the inner bearing? and did you change the seal? both should be done before even installing the rotor/hub onto the spindle.
yes...torque the first nut to 50 pounds, back off 45 degrees, install the washer (make sure to line up the little pin, you may have to move the nut to do so.) and torque the outer to 150 pds.
1 - 2 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.