Bronco Forum - Full Size Ford Bronco Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
580 Posts
Discussion Starter #1
--------------------------------------------------------------------------------

I have a set of Crane cobra full roller rockers on my 351W engine I am building. The intake manifold is off right now. What is the easiest way to adjust these? The motor has hydraulic roller lifters and they are pumped up good and firm.

I know they will probably need adjusting again after the motor has run a little.
 

·
Chillin on the Gulf Coast
Joined
·
1,596 Posts
When I did my buddies roller rockers we primed the oil pump before adjusting each rocker and once we thought each was good. Gave us a consistent baseline and the results were good.
 
1 - 2 of 2 Posts
Top