hydraulic clutch

1032 Views 4 Replies 3 Participants Last post by Blown, Jan 17, 2004

Timmy

Discussion Starter · Jan 17, 2004

quick question about my hydraulic clutch... I need to put a new hose inbetween the master and slave cylinders, I know that I can't use regular rubber hose because it will flex to much and not allow the slave cylinder to do it job but can I use high pressure mutli port fuel ijection hose or will that flex to much as well? :shrug

Save

1 - 5 of 5 Posts

Timmy

Discussion Starter · #2 · Jan 17, 2004

anyone???

Save

Crazed

· #3 · Jan 17, 2004

I dont know...i would go to a hydraulic shop, and ask them...?

Save

RLKBOB

· #4 · Jan 17, 2004

Why not just get some straight brake line and a tubing bender, that'll definetly work.

Save

· #5 · Jan 17, 2004

I found a store called "Tubes & Hoses" Specialty store like the Battery stores that have popped-up all over the country, see if you have one of those!

Save

1 - 5 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month