Bronco Forum - Full Size Ford Bronco Forum banner

Hydro or Manual Clutch?

1021 Views 6 Replies 3 Participants Last post by  85f150
I'm still planning out what direction I'm going with my bronco and what parts I'm going to use, but I've been debating about using a hydraulic or a manual clutch. I have an 81, which is manual, with an SROD. I just bought a NP 435 that came with a hydraulic bellhousing and brand new pressure plate and clutch. I'm not sure if I should just keep the manual or if I should put on the hydraulic while I'm at it. I am very happy with the manual that I have. I've drug out old rusted cars from a field, some with only 2 locked wheels (and 2 gone) and the clutch grabbed fine and everything. On my friends chevy cavalier (hydro) he said that his clutch was a little slow to engage when it was 40 below out. I know they're completely different kinds of vehicles and it might be different, but was wondering if anyone has encountered this? Once the fluid warmed up, he said it was fine though. Simplicity is very important to me, so hydraulic might not be the best route? I need to be able to fix whatever I have on my truck with the tools I carry. Also not sure what all extra I would need to get it completed. I guess the hydraulic pump would be it? I was just about to head to steve83's pics to check out what all I need but got sidetracked. I already posted a while back when I was thinking about buying this tranny/bellhousing if the clutch/pressure plate would swap into the mechanical but I didnt get any replies. Not sure if one is 10" and the other 11" or what. This turned out kinda long once again, but I thank anyone that replies with some info.
See less See more
1 - 1 of 7 Posts
I had teh red hose too until it started leaking at the clutch MC. You need to swap in a Clutch master cylinder also, you will prolly have to take a hole saw to cut the whole in your firewall. YOur cab may or maynot have the holes marked already where it is suppose to be mounted.

The only linkage you might be able to use over is your pedal assembly since that is just about the only linkage needed. Off the pedeal assembly is jsut a little bar then it connects to the clutch MC rod.
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top