Bronco Forum - Full Size Ford Bronco Forum banner

Installing 3/4 ton Chevy Rotors on Ford D60

3553 Views 4 Replies 4 Participants Last post by  BigNorm
1 - 5 of 5 Posts
So thets the "no grind for a 15" wheel setup" right?
norm , do you have pn# for the calipers and rotors or what's it off of ?
4
Crazedatwork said:
So thets the "no grind for a 15" wheel setup" right?
Basically yes, perhaps a tiny bit. that's what I am going to be running...front and rear. exact same parts, cheap, easy to find, what more could one ask for? Oh yea, high steer!

I've got the rears now Tim, and will be getting the front setup in the next month.

I don't have all the part numbers at this time, but as I piece this all together, I am going to take pics, and document part numbers used.

Rear 3/4 T. cheb pads/calipers(large single piston)/12.5" rotors (stock front TTB as a measure uses 11.5" rotors) on D60FF (Jim did the 3/8" plate mounts, better than what I've seen out there):



See less See more
badass1tonf100 said:
norm , do you have pn# for the calipers and rotors or what's it off of ?
I don't have the PNs per se but I know that all the parts used were ordered for an 82 3/4 ton chevy. The guy I bought the kit from said that the parts should interchange with 76-87 Chevy or Dodge 3/4 tons.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top