Bronco Forum - Full Size Ford Bronco Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
363 Posts
normal. just make sure that when you put the shaft back in it snugness that spline
 

·
Moderator
85 Bronco, 309ci I6 w/4bbl, np435, 4" lift, 37" Irok NDs, 4.56 w/ Detroit Locker and tru trac
Joined
·
18,098 Posts
Yup all good. I like to find them in the JY and pull them out. They make excellent punches and whatnot.
 

·
Registered
Joined
·
45 Posts
Discussion Starter · #5 ·
What about the torque converter insides sliding around unusual when I shake it? I’ve had it for almost two years now and just recently I have no gears. Left me stranded by my house and had to tow it back. Fluids were good and everything. Felt like something hit hard and after that no gears. I’ve got it out now and just going to take it to the shop it’s under warranty with.
 

·
~*~*~*~*~*~*~
Joined
·
10,787 Posts
You sure it's your trans and not your transfer case that went bad? Instant no gears to me sounds like transfer case.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top