Bronco Forum - Full Size Ford Bronco Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
2,352 Posts
Discussion Starter #1
I'm looking into lifts, i've pretty much made my mind up on a 4" kit, my question is this, if i replace the front bumper with a tube type will i be able to run 35's on 16x8 rims without trimming fenders? And, will there be any other possible places that they may rub?
 

·
Registered
Joined
·
2,352 Posts
Discussion Starter #3
Well, that was a well thought out, informative reply................NOT!

Thanks for that pearl of wisdom! :slap :iiss
 

·
negative creep
Joined
·
8,651 Posts
you don't have to listen to my advice. but I AM RUNNING a 4" lift and I AM RUNNING 33s and I CAN GET them to rub.
 

·
negative creep
Joined
·
8,651 Posts
the top lip of the fender, especially the rear axle. bumper probably wouldn't be a problem. also the corner of the fender opposite the bumper might rub.

my 33s rub the radius arms too, but i just need to adjust the steering stops and that would be fixed.
 

·
Registered
Joined
·
573 Posts
Andy351 said:
you can get 33s to rub if you really want to
:lolup :histerica :histerica :histerica
 
1 - 8 of 8 Posts
Top