Bronco Forum - Full Size Ford Bronco Forum banner

1 - 14 of 14 Posts

·
Some assembly required!
Joined
·
5,402 Posts
Discussion Starter #1
Dana 60 35 spline open carrier
$30 plus shippingSOLD!
.
.
Stock front Dana 60 35 spline open carrier with side gears, spiders and cross pin. It came out of a '79 HP D60. It's a little rusty, but it'll clean up just fine.


.
.
10.25 limited slip carrier with 4.10 gears and diff cover
$60 plus shipping
.
.
10.25 limited slip carrier with 4.10 gears and diff cover, good condition.
.


.351W EFI intake plenum gasket
$6 shipped
.
.
351W EFI intake plenum gasket, goes between upper and lower intake.

.
.'78-'79 power steering hose
$13 shipped
.
.
'78-'79 power steering high pressure line, new and unused.

.
.Front drive shaft u-joints
$20 shipped
.
.
Front drive shaft u-joints for my '90 Bronco. Used as trail spares, installed once and never used.

.
.Ford Racing locking header bolts
$35 shipped
.
.
Ford Racing locking header bolts of the 1" variety, new and never installed. Sells new at Summit for $57.88. SOLD!


Permacool remote oil thermostat
$25 shipped
.
.
Permacool remote oil thermostat, used to bypass either tranny or engine oil cooler in cold weather for proper warm up. New in package, unopened. Sells new at Summit for $41.88.SOLD!



.Steering rag joint and lower shaft
$15 shipped
.
.
Good used steering rag joint and lower half of steering shaft, came off of an '87 Bronco if I recall.

.
..
.
Location Charlotte, NC
ZIP CODE (for shipping calculations):28227
Will you Ship? Yes
Method of shipment (UPS, FedEx, etc):Fed-Ex or UPS
Payment method (PayPal, check, MO, etc):paypal, cash, money order
.
 

·
Registered
Joined
·
1,264 Posts
pm'd.....again lol (regarding locking header bolts.)
 

·
Formerly vt89gtvert
Joined
·
2,425 Posts
PM'ed you on remote oil thermo
 

·
Some assembly required!
Joined
·
5,402 Posts
Discussion Starter #5
U-joints sale pending.
D60 carrier sale pending.
Header locking bolts sold.
Oil cooler thermostat sale pending.
 

·
Registered
Joined
·
1,863 Posts
Hey, Dave, I am gonna pass on the 10.25 gears, after talking with the wife and researching some more, we decided that it would be best to just wait and get some 4.56 gears since my next tire purchase will be 35's
 

·
Wrenching for a Livin'
Joined
·
6,949 Posts
dang dave....i know you i know you always talked about all the extra parts you needed to sell....guess the garage was getting crowded again, haha

bump...
 
1 - 14 of 14 Posts
Top