Bronco Forum - Full Size Ford Bronco Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
324 Posts
If you havent already done it. Go to NAPA and get the inset body molleys. You want to 1/4". Read the instructions that come with them. Have someone hold the visor and mark the body with a marker where the holes are. Drill the size hole for the molley insert them in the hole then put the visor on and bolt it in. make sure you use a low profile bolt head so you can cap them off so the finish look is clean.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top