Bronco Forum - Full Size Ford Bronco Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
656 Posts
Discussion Starter #1
whell, i finally broke my driver's side front yoke. It broke right at the u-joint on the driver's side tire.....the shaft that goes through into the hub.

This sorta sucks....BUT, i pulled the whole axle shaft out of my other 89', and i want to install that.....BUT it has auto-hubs. Before i go and pull my truck apart, are the shafts the same?

Thanks guys....also any tips on getting the u-joints out? they have a wierd inner circlip and its rusted to hell....its been soakin in PB, but it wiont move.
 

·
Dead Horse
Joined
·
5,935 Posts
yes there the same because i swapped from auto to manual and still using the same shaft
 
1 - 2 of 2 Posts
Top