Bronco Forum - Full Size Ford Bronco Forum banner

manual hubs

794 views 7 replies 4 participants last post by  monkeyhouse 
#1 ·
i know theres prob tons of threads on this but i didn't find one...i was wondering if i had to have the conversion kit or just warn hubs...a friend told me i just need the hubs but im just making sure....i have a 1992 bronc..i know i prob sound stupid but i think i have the Dana 44 31 spline but i dont know so if ya'll could tell me thanks
 
#3 ·
92 SHOULD BE FINE. THE 95'S AND 96'S ARE THE PRIMARY CULPRITS THAT NEED THE CONVERSION KIT. WHICH BY THE WAY, YOU CAN BUY THE NUTS AND WASHER THROUGH NAPA FOR HALF THE PRICE OF THE WARN, IT IS JUST THE REPALCEMENT PARTS FOR THE OTHER YEARS.
 
#4 ·
yes there are a ton of threads on this exact subject, you should try searching, and then READING them.

no, you do not need the conversion kit if your spindles and hardware are the original ones from 1992.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top