[Drilim]

You F&^king sickos. In the next weeks, ill be gathering parts to install my lift. 4'' Dick Cepek with Superlift arms. Probably gonna do 2.5 or 3'' add-a-leafs in the back with new rear springs.

Also came with a PA.

Any advice, Tips, Hints as for stuff to do while ive got all the parts sitting here? Or while i have the TTB off? (besides put in a 60)

 

[Andy351]

get a bit more length. 4" isn't enough to please the ladies:goodfinge



check brakes, u joints, tie rods, extend diff breathers, tie rod flip.
the best way i found to get rivets off way to grind the heads down, drill a couple of small holes in them and use an air chisel with a pointy tip to knock them out.
use ratchet straps to hold the beams and lower them/raise them on and off of the ground.
buy cobalt drill bits and good grinding disks.
make sure you have most of the stuff you need, it sucks when you are working on it alone, need to get parts and there is no one to drive you to the store.

 

[godless]

Try to get a torch or plasma to cut off teh rivets.
Besides that give yourself plenty of time.
Have fun:thumbup

 

[78Bronco4x4]

4" sounds bout right for midget sex.:lolup

 

[gobucs]

Ouch :lolup