[Broncoholic]

ok the first noise I was right it was the drivers side bearings the inner one was commpletely gone so I replaced them. Took it out to test drive tonight and still a clunk clunk on that same side what is it?

 

[Blaze]

:wtf I have no idea what your talking about....:shrug

 

[Seabisquit]

clunk-clunk..

Check your radius arm bushings..

 

[rem_243]

There has already been a post covering this.

http://www.fullsizebronco.com/forum/showthread.php?s=&threadid=8160

 

[Broncoholic]

nope I believe you are wrong .
that has or had nothing to do with it .
I just got a ride home because the new bearings I put in and I did it all right
they just all came back out while I was driving down the road tire, rotor, and all
so it sux to be me
thats enough for now
now I have to go fix it

 

[Damager]

if everything just all fell out, I would doubt it was done correctly

 

[Lookinfurfun]

if everything just all fell out, I would doubt it was done correctly

:stupid


Did you check the needle bearings? Are your hubs locked in? If so, did you try to unlock them and see if the same sound is there?

 

[jermil01]

nope I believe you are wrong .
that has or had nothing to do with it .
I just got a ride home because the new bearings I put in and I did it all right
they just all came back out while I was driving down the road tire, rotor, and all
so it sux to be me
thats enough for now
now I have to go fix it

Bearings just don't fall out...unless the lock ring was not installed appropriately and torqued down.