Bronco Forum - Full Size Ford Bronco Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
250 Posts
Discussion Starter #1


This is out of a 91 dually with 4.10's. I paid $550 for it. They had another one that was sitting in an 88, but it's not listed on car-parts.com any more.

I plan on putting it into this

 

·
Registered
1996 Bronco 5.0/E4OD/BW1356
Joined
·
1,488 Posts
Pictures not working - oh and a $550 D60 - you suck :goodfinge
 

·
Registered
Joined
·
250 Posts
Discussion Starter #4
Figured out how to post pics. I got it at Aumillers West in Lewisberry PA.
Their number is 717-938-4000 if someone wants to call about the one out an 88.



Ah, an insult & the little red devil. I feel at home!!
 

·
Registered
1996 Bronco 5.0/E4OD/BW1356
Joined
·
1,488 Posts
Hehe - i just paid $800 for one last weekend and it wasn't even painted like yours...

No harm intended - welcome to FSB. Post in the Intro section.
 

·
Engineer
Joined
·
13,163 Posts
Good deal on the axle.
 

·
Registered
Joined
·
1,024 Posts
yea $550 for a dually front is normal going rate. you gotta change out the hubs for a single wheel. Hubs aint cheap either....
 

·
Registered
Joined
·
250 Posts
Discussion Starter #8
yea $550 for a dually front is normal going rate. you gotta change out the hubs for a single wheel. Hubs aint cheap either....
I was thinking of getting custom backspaced wheels instead of changing the
hubs, or scrounging up some d50 ttb hubs at the u-pull.
 

·
Wrenching for a Livin'
Joined
·
6,949 Posts
I was thinking of getting custom backspaced wheels instead of changing the
hubs, or scrounging up some d50 ttb hubs at the u-pull.
d50ttb hubs all the way

or you can run h1 wheels without recentering them
 

·
Registered
Joined
·
250 Posts
Discussion Starter #10
d50ttb hubs all the way

or you can run h1 wheels without recentering them
I think the H1's are 8.25" wide stock. I was looking for 10" preferably 12" wide wheels. Also, I'd have to get the h1's recentered for the rear axle. I think the widest 8 lug rear axle is a d70 for a chevy dually (72" wms-wms).
The d60 I have now is 78.5" wms-wms.
 

·
Wrenching for a Livin'
Joined
·
6,949 Posts
that is a wide axle. didnt realize it was THAT wide. But yeah....id just grab some ttb d50 hubs. I ran across a thread on pirate....that i apparently lost the link to, but it showed that the differences between the d50 and d60 ttb hubs are VERY minimal. All the vital mesurements are the same.

Just don't use the spindles. ;)
 
1 - 11 of 11 Posts
Top