Bronco Forum - Full Size Ford Bronco Forum banner

1 - 17 of 17 Posts

·
Registered
Joined
·
1,239 Posts
Discussion Starter #1
By now you have all seen our truss design for our housings. It gets superior strength through using the crown shape.



But now how about the same strength and shape for a factory 9" housing?



This is the rear truss, the top truss will have integral links and should be ready within a couple of weeks. The truss is long enough to end at the brake brackets so you do not have any weak points. The IFS Toyota should be done by the end of next week also!

http://www.ruffstuffspecialties.com/catalog/9FACTORY.html

 

·
Registered
Joined
·
1,239 Posts
Discussion Starter #10
any pics of them with spring perches welded on? it looks like it doesnt give enough room for perches but could be just the pic.
We are working on a Ubolt die to make a "D" shaped Ubolt that would have a straight side and go through a tube. I will let you know...
 
1 - 17 of 17 Posts
Top