[Graydevil]

I drove home no problem but when i turned the truck off now I have no power inside it did this before and i replaced the wires and starter silinoid and then i had power again. I checked my conections on bat and silinoid they are good and tight don't know what the heck it is.. Hope some one can shed some light on this..

 

[Streetgang]

When you say "inside" are you talking about the dash & dome? Come to think of it your post is sort of hard to understand........but it could just be me???

 

[imlikeojnow]

Do you have power on the outside of your truck?

 

[Graydevil]

Ya I don't have power is side of truck no dome or power to the key to start..

 

[imlikeojnow]

check for a bad ground or an exposed or grounded hotwire

 

[collinsperformance]

clean the contact area of the starter relay and make sure you put all the wires but the starter wire on the same side of the battery. i think there are 4 yellow wires that supply constant power to the different spots in the bronco......mike

 

[Graydevil]

Found the freakin problem I gess my 100 amp alt burned up the wireing harness.. Just what i want to do on the 4th make a new wire harnes.. Dam I wish i had all the stuff to put my 3g in..:whiteflag