Bronco Forum - Full Size Ford Bronco Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Okay it is me again. I was wondering if anyone could help me with these two problems.

First off my gauges in my bronco were not working, so I bypassed them and got some aftermarket ones and installed them. However my oil pressure gauge reads 75 psi when it first starts, but when I start driving around it will drop to 25 psi at idle and then shoot back up to 75psi when I start moving. Is this normal?


My second problem is that I have a 1980 ford bronco that is completely stock. The guy who had it before me pulled the fuse cover from a new, or older, I am not sure, bronco and put it in this one. So the diagram is no correct. Does anyone know where I can find one for a 1980 bronco? Full size with a 351 5.8L v8 if that helps any.
 

·
#1 Asshole
Joined
·
1,452 Posts
Yes every one I have ever had fluctuates with a mechanical gauge and junk yard, national parts depot or lmc
 
1 - 2 of 2 Posts
Top