Part number or size/thread count?

220 Views 6 Replies 3 Participants Last post by Swayback, 9 d ago

Swayback

Discussion Starter · 14 d ago

Does anyone know the part number or type of anchor nut I need to get? This is the rear wheel well of a 94 where the seat belt retractor goes. I looked at the diagram another post had but it said M12– I measured it and it seems to be an M10.

See less See more

Save

1 - 7 of 7 Posts

Swayback

Discussion Starter · #2 · 14 d ago

This is the post I was referring to: What size bolt attaches the seat belt buckle to the floor?

Save

wileec

· #3 · 14 d ago

I know the bolts that hold down the drivers seat in my 95 are M10 150 just got a replacement for the one that fell out when I pulled my bracket.

Save

wileec

· #4 · 14 d ago

With that said I also replaced the seatbelts for that seat and IIRC the bold were 7/16 fine thread.

Save

Swayback

Discussion Starter · #5 · 14 d ago

Thanks! I picked up stainless steel large washers, locking washers and M10 bolts.

Save

Boomhower

· #6 · 9 d ago

Swayback said:
Thanks! I picked up stainless steel large washers, locking washers and M10 bolts.

Did that work?

Save

Swayback

Discussion Starter · #7 · 9 d ago

Boomhower said:
Did that work?

Yes. Perfectly. I picked them up from Home Depot

Save

Reactions: 1

1 - 7 of 7 Posts

Top Contributors this Month