Bronco Forum - Full Size Ford Bronco Forum banner
1 - 4 of 4 Posts

· Diesel Gynachologist
Joined
·
10,736 Posts
How much change?
I dont remember but it was not cheap. i wanna say about a hundred bucks or more.. worth every penny though
 

· Diesel Gynachologist
Joined
·
10,736 Posts
The arm was so far up on the splines we had to grind down the 2 jaw puller just to get on it. I've used that type of puller Dustin posted too and I'm not sure it would have worked here either. There was hardly any room to get any leverage on it.
thats why I say its for ford boxes. they sit that high normally. This puller is thiner to fit and has alot more surface area so it does not break off. you need to unbolt the box to drop it down a tad to get it in there then hit that bitch with an impact and it will come right off.
 

· Diesel Gynachologist
Joined
·
10,736 Posts
Maybe with dropping the box it would work. I'm telling you though, that bitch was STUCK.
I know been there done that. i just lowered the box a bit and used that puller on mine a couple times. easier than those junk 2 jaws
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top