Bronco Forum - Full Size Ford Bronco Forum banner

Build a Base Model Bronco or Go Fully Loaded?

  • Build a Bronco

    Votes: 5 83.3%
  • Go Fully Loaded

    Votes: 1 16.7%
1 - 6 of 6 Posts

·
Registered
Joined
·
268 Posts
Discussion Starter · #1 · (Edited)
For 2021, Ford has made 7 Bronco models available, with price ranging from $28,500 - $59,305 to suit all budgets. Whether you want to start on the lower end and build your own, go for a fully loaded model or be somewhere in the middle, there's something for everyone. What are reservation holders here are planning to do?
 

·
Premium Member
1986 Bronco, 351w, Edelbrock aluminum top end, Holley 600, 4" BDS lift, 35" Maxxis Razr's, stuff..
Joined
·
2,650 Posts
I’ve loved wrenching on stuff my entire life. Base 30k plus 10k of mods plus my time and labor equals 50k. At 50 years old (when the f did that happen) I think if I was going to get one, which is doubtful since I have always run old iron, I would just pull the trigger on the Ford engineered / after market add ons and drive the paint off it.

For 50k I could do every mod in the book to both of my bullnose broncs and be happy as a clam.


Sent from my iPhone using Tapatalk Pro
 

·
Registered
Joined
·
138 Posts
I haven’t even been able to get to the build page yet. My thoughts are bade and build from there.


Sent from my iPhone using Tapatalk
 

·
Chicks dig my
Joined
·
1,423 Posts
I am shooting for a Badlands with the V6 and 35's options. I don't have the wrench time I used to and I just want to get in it and rip it.
 

·
Registered
Joined
·
268 Posts
Discussion Starter · #6 ·
I am shooting for a Badlands with the V6 and 35's options. I don't have the wrench time I used to and I just want to get in it and rip it.
That's precisely where I'm at. Done wrenching and just want something good enough. Big Bend is likely what I will get and with the help of a local shop, modify over time as aftermarket parts come out.
It should be like the Wrangler with lots to choose from.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top