Bronco Forum - Full Size Ford Bronco Forum banner

1 - 20 of 66 Posts

·
Living in Obscurity
Joined
·
1,928 Posts
 

·
Registered
Joined
·
96 Posts
Before
After. This pic is about 9 months old. Since then I've add a Mallory Hyfire IVa ignition box and a Mallory coil, a Optima red top battery and a 160 amp Alt. I just don't have any new pics.
 
B

·
Guest
Joined
·
0 Posts
302, forged pistons, powerdyne blower (9lbs.), World Products heads (200cc intake 2.02int 1.60ex.), Comps Speed Density cam (Lobe center 114, duration 250int 260ex .462int & .474ex) Fomosport Mass air conversion, 70mm to 30lb injectors, K&N filter, headers, 3" single exhaust turned down before the rear axle. (No smog pump)

 

·
But what does mine say?
Joined
·
954 Posts
Ignore the rat's nest. Thanks to some roadside repairs, everything is just thrown together. I have yet to straighten anything up. When I do, I'll have some more pictures to post.


 

·
Screw the Jeep Thing
Joined
·
4,522 Posts
Right Before I pulled the motor out of the truck.. HMMM CLEAN huh!!!


Outta the truck and on the ground. Look at all the lovely vacuum lines:banghead


What I pulled outta my engine.:cry


Put back together and ready to go back in.:thumbup


Engine ready to finish up and go Wheelin:beer


Wish I had a shot of it all finished up before I went wheelin but guess I dont:twak
 

·
Registered
Joined
·
34 Posts
Rebuilt 351W High Output with Edelbrock 600cfm 4BBL Carb and Edelbrock Performer Intake, Crane Cam, Hedmann Headers, Mallory Ignition and Distributor, Silicone Spark Plug Wires, Platinum Plugs, Dual Exhaust.

Horsepower, Torque, and MPG? Who knows and who cares, she's plenty fast enough for me and drinks a lot of gas. :thumbup



 

·
FSB warrior
Joined
·
6,118 Posts
Bronco85 said:
Right Before I pulled the motor out of the truck.. HMMM CLEAN huh!!!


Outta the truck and on the ground. Look at all the lovely vacuum lines:banghead


What I pulled outta my engine.:cry


Put back together and ready to go back in.:thumbup


Engine ready to finish up and go Wheelin:beer




Wish I had a shot of it all finished up before I went wheelin but guess I dont:twak
any reason why you didnt cut the unused portions off the bracket, ground them smooth and panted them


 

·
Living in Obscurity
Joined
·
1,928 Posts


This picture kills me. In my head I'm always thinking "need this much for this lift component, I need this much for tires, I need this for gears and lockers etc..." But I see that pic and all I want is that really nice intake.

I swear my mouth waters when I see it.
 
1 - 20 of 66 Posts
Top