Joined
·
16 Posts
Is your speedometer and odometer not working at all, is your ABS light on? shifts but only when the RPM's go over 3? Not to sure if this is your problem.
problem
Join the discussion
Recommended Reading
-
Sound barrier material
1980-'96 Bronco TechSo I’m sure there are 100 different opinions on this stuff but I’m about to strip my interior out, install a full sound system and while I have my interior out I’m wanting to insulate it. Obviously we’ve all heard of dynamat and lately I’ve seen noico on eBay but I had a buddy tell me about...- 19
- 493
-
mattmann · updated
-
E40D Filter change ?
1980-'96 Bronco TechOk so I'm about to drop the pan again and install the Punisher VB. About 2,000 miles ago I dropped the pan and changed the filter and put fresh fluid. Should I replace the filter again when I put in the VB or just drop new fluid in it? I was gonna leave it but wanted suggestions...I have a...- 1
- 37
-
Bayou96errr · updated
-
Timing at 30 degrees
1980-'96 Bronco TechI got problems. First I was having idle issues. Checked codes TPS and EGR came up. Replaced TPS then gas pedal would not work. Replaced TPS again. Every sensor and replay- 6
- 89
-
1986 ford bronco 5.0 starts & dies
1980-'96 Bronco TechMy 86 bronco will start then die with in seconds .I replaced fuel filter .Replaced the fuel pump in the gas tank . Replaced the fuel relay . On the fuel rail i checked to see if i had fuel presure i have alot of air very little fuel . So i cycled the key about 10 times .Got it to start it ran...- 5
- 83
-
BBICWill · updated
-
Issues with installing sway bar on Ford 9" housing
1980-'96 Bronco TechHi all, I currently removed my 8.8" and am installing a Ford 9" into my '85 Bronco. However, I noticed right away that there are alignment tabs on the 8.8" housing for the sway bar brackets that are not present on the 9" housing. With as much highway driving as I do, I'd really like to...- 9
- 515
-
AbandonedBronco · updated
Join now to ask and comment!