Bronco Forum - Full Size Ford Bronco Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter #1 (Edited)
I am rebuilding a 351w. A friend was helping to clean up some parts. We managed to keep the pushrods in order (by cylinder). But the orientation (up or down) is uncertain. All I have to go on is a little bit of crud that has built up towards the end of each shaft. Does anyone know if this would this appear near the rocker arms or lifters. Our should I just buy new. Thanks.

Bronco 010sm.jpg
 

·
Satyr of the Midwest
Joined
·
17,738 Posts
Just buy new ones; they're only a buck each (or less) for factory-style pieces at most auto parts stores.
 

·
FSB warrior
Joined
·
6,113 Posts
ya if the tips are worn at all its gonna hurt performance, not to mention slight bends, and the oil holes being clogged up
 
1 - 3 of 3 Posts
Top