RABS speed sensor

282 Views 1 Reply 2 Participants Last post by miesk5, Sep 29, 2020

QuantumMechanic

Discussion Starter · Sep 29, 2020

So, the PO must have sealed the rear axle on this bronco. The speed sensor that is supposed to be on the rear diff is kinda wound up in a ball and zip tied to the axle. The pumpkin didn't appear to have a place to mount the sensor. Does anyone have any ideas or suggestions?

Save

1 - 1 of 2 Posts

miesk5

· #2 · Sep 29, 2020

Yo Q,
Perhaps a previous owner or shop replaced the original 8.8.

From around 1985 through 1991, Ford used a transfer case mounted VSS for cruise and E4OD, if equipped, shifting. The ABS sensor was only used for RABS.

RABS Component Location Info in an 88 (click NEXT to View more pages)

Source: by Jem270 at SuperMotors.net

See less See more

Save

1 - 1 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Home
Forums
Bronco Discussions
Noobie Bronco Tech Questions. Flame free zone!
RABS speed sensor

Top Contributors this Month