radius arm compatibility?

970 Views 10 Replies 6 Participants Last post by rkymtnbrnc, Oct 8, 2008

whitneyj

Discussion Starter · Oct 6, 2008

are the radius arms cast as a left and right or cast as a universal set and drilled for the coil buckets?

Save

1 - 1 of 11 Posts

rkymtnbrnc

· #11 · Oct 8, 2008

bmc69 said:
They are different. I just layed two side by side. One had the threaded end on the right side and 'C' on the left. The other was opposite. I turned both around and still got the same result.
.
.

.
.
.:toothless

If you would get a torch & cut the threaded doo dad off they will be the same.

Save

1 - 1 of 11 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.