Bronco Forum - Full Size Ford Bronco Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
145 Posts
Discussion Starter · #1 ·
So I have welded in a patch to a completely rusted out rear most body mount hole (sill position) on my rebuild (both sides). I cannot find the measurements of it's position anywhere. If someone has a measurement of the rearmost hole from say the 4th position(working from front to rear, 1 is radiator body mount, 5 is the rearmost), could you post please? I've seen the the '92 diagrams of metric locations but I may not be measuring from the correct locations because some things are not jiving. I'd prefer not to have to drop the body back on the frame.
 

·
Registered
Joined
·
1,672 Posts
Take this with a grain of salt, but I measured from the center of the 4th position cover to the center of the bolt head at the 5th position and it was 26". I didn't remove the cover so I'm building in some assumptions about cover location relative to bolt hole location.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top