Bronco Forum - Full Size Ford Bronco Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
89 Posts
Replacing vacuum lines

This thread was very informative. I took a slight twist to the concept and replaced the vacuum lines with brake line that can be bent to fit using simple hand tools. I cut off the factory ends which were set up for compression fittings and used the same rubber hose on each end to connect to each sensor/valve. Crazy glue does a great job sealing the hose to the brake line. The other end just slips over the sensor/valve. I even painted the lines to match factory colors so I don't get mixed up. You couldn't tell the difference unless you reach in and touch them. These lines should hold up very well to heat. I found it best to remove the upper intake to dry fit the lines.
 
1 - 1 of 1 Posts
Top