[spaceexplorer23]

In my '93 ever time i put it in reverse there is a pause and then an audible clunk before it actually goes into gear.....note: the tranny has been rebuilt and the rear u-joints were replaced not long ago.

it's just so annoying:doh0715:

 

[SigEpBlue]

How's the transmission and engine mounts? Is the slip yoke lubed?

 

[spaceexplorer23]

i've never noticed anything wrong with the engine mounts and i had to do all the tranny mounts and stuff when i took it out to rebuild it.......and for some reason i'm drawing a blank on the slip yoke.....a complete blank

 

[slim]

How long ago were the Ujoints changed? I would check them again.

 

[Steve83]

It doesn't matter when anything was changed or rebuilt. Get under there & look around. The U-joints are the most likely; the rear pinion nut is next.

.

 

[Ragged_ol_86]

Mine pauses then clunks. But the motor and trans twists hard to pass side. so i have a shot trans and motor mount. look into that. BTW my ds is new from tcase to rear joints and all.

 

[redbroncorollin]

its your 8.8 rear end, my 88 did the same thing as it wore out and finally blew up, rebuilt it and got rid of the clunk

 

[beisel1111]

Mine did the same thing. I tightened the rear pinion nut and it went away.