Bronco Forum - Full Size Ford Bronco Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
158 Posts
Discussion Starter #1
Replaced the valve cover gaskets, dizzy cap and rotor. Noticed my spout connector is MIA. Can I hard wire it until I can get to the dealership????
 

·
Registered
Joined
·
158 Posts
Discussion Starter #3
Thought so. Thanks for the confirmation Gacknar!!!!!
 

·
Registered
Joined
·
158 Posts
Discussion Starter #5
welndmn said:
Just go to the wreck and get one.
If not, I have one I can mail out.
Read my mind. Am going to try and take a trip out to local pullnsave and see what i can find. If i cant find anything, l'll be pm'n you. Thanks!:rockon
 

·
Registered
Joined
·
39 Posts
I searched, now I resurrect this thread. While doing the ignition upgrade and bump I found no spout connector also. I am correct in reading that all the SC does is make a connection and allow the computer to vary the timing? This means a length of wire and two male ends would suffice till I find a real one at a wrecking yard? Thanks. I bet my power and MPG is going to improve!
 
1 - 6 of 6 Posts
Top