Bronco Forum - Full Size Ford Bronco Forum banner

1 - 8 of 8 Posts

·
Premium Member
Joined
·
557 Posts
Discussion Starter #1
here is what i have started to do, since i have some time to kill with some vacation time, due to the holidays. I have still got to do some fine tuning, and then fiberglass the console, prime and paint, but here is a pic of where i am schematically anyhow. I just have to make some holes for the cb, a bracket for the ipod, and run some wiring underneath. this is a rough draft for the center console that i am going to mount by column replacement shifter to, and then my floor shifter for the new transfer case.
 

·
Engineer
Joined
·
13,165 Posts
Looks good so far keep us posted. A deeper cup holder might be a nice addition
 

·
Practicing Infidel
Joined
·
15,309 Posts
Great start

that's one of the lower profile one's I've seen.

Sixlitre
 

·
Registered
Joined
·
5,024 Posts
Kewel...I like the use of metal as opposed to wood, will be sturdier and lighter as well...
 

·
Registered
Joined
·
6,177 Posts
Just a question, how much are you projecting to spend on one of these? Reason is I'm dead flat broke but my dad works at a lumber store and can get wood for free/cheap, so I was thinking of making one of these. I don't know how much everything else costs, but I'm betting fiberglass and vinyl isn't cheap.

(what else is involved besides screws, hinges, and some wood glue?)
 

·
Registered
Joined
·
238 Posts
ToddACimer said:
Looks good so far keep us posted. A deeper cup holder might be a nice addition
Here, Here!!!
 
1 - 8 of 8 Posts
Top