Bronco Forum - Full Size Ford Bronco Forum banner
1 - 9 of 9 Posts

· insanity & senselessness
Joined
·
1,346 Posts
Discussion Starter · #4 ·
Yo Paulo,
Congratulations on your power train enhancements!

If I recall, you have been planning the 6BT for awhile.

Keep in touch here friend!
Al
Hi man, Thanks

This project is taken me so much time.

I´m not a professional a builder or welder. I work in an office and this is just my hobby.

btw I took a pair of Dodge Ram 2nd gen engine mounts and I made these adapters to the frame.

Hood Automotive tire Motor vehicle Vehicle Automotive exterior
 

· insanity & senselessness
Joined
·
1,346 Posts
Discussion Starter · #5 ·
Hi @abrojal, I do remember your Bronco from a while back. Nice to see you on the site again. Looks like you've been busy. The engine install is super clean..How about some video of you driving it around??

Thanks man!

It´s not finished so, there are no diving vids o_O

Im working on the transmission crossmember and the rear axle too

btw I will need a new double cardan, and big transfercase yoke. My D 70 uses 1410 universal joint.
 

· insanity & senselessness
Joined
·
1,346 Posts
Discussion Starter · #8 ·
Let me tell you this..For a guy working in an office you have some pretty good fab skills.
Thanks, I have professional builders friends, and I have learned a lot with them. I have seen many "fummins" projects and I have taken some ideas from them.

I did a "carnage" with the Radiator Core Support Mounting to make room for the intercooler. Basically half of the intercooler is inside the Core Support now.

Building Engineering Gas Hood Automotive tire
 
1 - 9 of 9 Posts
Top