Bronco Forum - Full Size Ford Bronco Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
227 Posts
Discussion Starter #1
I just replaced the rear driveshaft on my 91. I was looking for the torque specifications for the 8 bolts that secure the shaft to the Axle and T-Case Flanges. I'd look it up but I loaned my Hayes manual out to a guy at work and haven't seen it since. :banghead
 

·
Banned
Joined
·
19,372 Posts
On circular rear axle companion flange applications, install the bolts retaining the driveshaft flange yoke to the circular rear axle companion flange. Tighten to 95-129 N-m (70-95 lb-ft).

 
1 - 4 of 4 Posts
Top