Bronco Forum - Full Size Ford Bronco Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
I have a 83 bronco full size with 300 6cyl,the tranny is bad but is automatic.
I also have a 83 ford truck 2 wheel drive same motor as bronco with auto tranny that is good shape can I swap them being one is 4-wheel drive and the other being 2-wheel? If so how much trouble will it be?
Thanks
 

·
Administrator
2012 Jeep JKU
Joined
·
22,859 Posts
you will have to swap the tailshafts between the two trans...basically take each trans apart and put them back together.
 

·
my bko ate my money
Joined
·
2,319 Posts
nope just gotta take both trans apart and swap output shafts, then reassemble the trans and good, might as well rebuild it while its in peices
 

·
Registered
Joined
·
562 Posts
Yeah, just swap the tail shafts............ piece of cake.

:whiteflag

Like everyone here has or can do that on their own.

I know that I wouldn't try it.

:toothless
 

·
my bko ate my money
Joined
·
2,319 Posts
if you aint got experiance dont bother tryin, i know i can but i did my E4OD rebuild myself with the help of a very good write-up
 

·
Registered
Joined
·
562 Posts
Yeah, tranny's are about the only thing that I have never ripped in to (yet).

With the right tools and manuals, I guess anything is doable. I'm just not ready to be my own guinea pig yet. Too much work to R&R one only to find out that you didn't get everything just right.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top