Bronco Forum - Full Size Ford Bronco Forum banner
1 - 1 of 1 Posts

·
Offical FSB Map Maker
Joined
·
3,033 Posts
It's your ujoints. Rebuild you driveshaft. It's not that hard a job. If you have a haynes manual just follow the steps and you will do fine. When you get to the CV (double cardan) joint that gets a little tricky as far as getting the two joints out and in. But follow the manual and you will do fine.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top