Bronco Forum - Full Size Ford Bronco Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
2,825 Posts
Here are the highlights of my rebuild:

Ford Motorsports MAS (Mass Air Sensor) conversion, Competition Cam 280H Magnum Roller Camshaft, Forged Pistons, Heads Ported and Polished, Intake "cleaned", Custom Ground Push Rods, New Injectors, MSD-6 Off-Road Ignition Module, Full Length Hooker Headers, Custom Y-Pipe and Exhaust, New Catco Catalytic Converter and Flow Master Muffler (2.5” pipe).

Don't have any dnyo numbers but this motor rips. Could get more HP if I replaced the heads and intake but would have lost torque so I didn't go that route. This was a complete tear down and rebuild.

This motor has no problems moving this Bronco with 37's and 4.10's.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top