Bronco Forum - Full Size Ford Bronco Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
66 Posts


I just used 1.75x.25 wall DOM from the frame to slider, 3/8" plate on the frame, and 1/2" backing plate behind frame, simple enough. As far as I'm concerned, two .250 wall tubes is plenty support for the slider, but only time will tell.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top