Bronco Forum - Full Size Ford Bronco Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
54 Posts
Discussion Starter · #1 ·
So I know many questions have been asked before about vacuum lines pertaining to the tab/tad/evr solenoids. I haven’t seen anyone make a post with the vacuum lines routing through all of the solenoids in the way that mine are. I found this thread but was wondering if anyone can tell me if:

1. Is there supposed to be a vacuum line that passes through every solenoid?
2. Where would the line that connects through all the solenoids on the end run to?
3. Is there an easier way to route the vacuum lines without using this weird contraption that connects them? Thanks
 

Attachments

·
Registered
Joined
·
1,706 Posts
So I know many questions have been asked before about vacuum lines pertaining to the tab/tad/evr solenoids. I haven’t seen anyone make a post with the vacuum lines routing through all of the solenoids in the way that mine are. I found this thread but was wondering if anyone can tell me if:

1. Is there supposed to be a vacuum line that passes through every solenoid?
2. Where would the line that connects through all the solenoids on the end run to?
3. Is there an easier way to route the vacuum lines without using this weird contraption that connects them? Thanks
That is exactly how mine were/are routed
 

·
Super Moderator
Joined
·
28,815 Posts
Yo J,
184502
184503
184504
 
1 - 8 of 8 Posts
Top