Bronco Forum - Full Size Ford Bronco Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter · #1 ·
I am looking for a good complete engine or complete rebuildable Ford engine 302 or 351 FI.

let me know what you got,condition, price and location.

You can PM me or email me direct at [email protected]

or Call me at my Cell #615-426-7819

Thanks,

Phillip
Fairview, TN
 

·
Registered
Joined
·
1,589 Posts
I have a 95 351W motor that started right up before I pulled it. nt sure why the van was in the junkyard but the motor ran. had a slight miss to it but it sounded pretty good and didn't smoke at start up. This motor may or may not have the roller cam in it but the 94 and up 351W blocks are roller cam ready. All the EFi stuff is still on the engibe but I sold all of the van brackets already. I do have the serpo set up from am 89 F250 that I can toss in. Asking $500 but i am at the North end of Ohio near Cleveland.
 

·
Registered
Joined
·
50 Posts
Discussion Starter · #5 ·
RE: Engines

I really do appreciate all the offers for engines but with gas prices as high as they are, I can't really afford to drive that far just to get an engine.

Thanks, I'll keep lookijng for one closer,

but I do really appreciate it.

Phillip
 

·
Registered
Joined
·
3,424 Posts
got one in pa...i could maybe drive a little...take your pic... 67 galaxie bare block w/ rotating assembly aside...ran good

91 302 complete motor w/ 80,000 on it and new bottom end 10k ago

in pa

dc
 
1 - 9 of 9 Posts
Top