[broncobandit]

I am thinking about getting this diff cover to use to make it so that I dont get axel wrap.

I was wondering if you guys think that it would be strong enough or if it would place to much stress on the diff cover bolts. It is made out of aluminium. I was planning on running a link from the diff cover to a cross member, with heim joints on the ends. Just looking for some feedback

:thumbup

 

[Davids78Bronco]

I think you can make your own, for half what that one cost - even with the diff protection

 

[Andy351]

i think it looks cool and would definitely serve its purpose, but like david said you could probably make a bracket on the top of your diff and reinforce your cover for much less money.

 

[WES]

i think it would be better and stronger to have a tube that goes to the tubes just outside of the centersection and ties into the center section so it is almost bulletproof, then mount your link on that

wes

 

[TTBlows]

I'm sure it's strong enough but single link setups use the leafs to triangulate so they can still wrap some. Not an ideal setup IMO