Bronco Forum - Full Size Ford Bronco Forum banner

1 - 3 of 3 Posts

·
Premium Member
Joined
·
149 Posts
Discussion Starter #1
Upon replacement of the original heater motor (yes the original) the rubber fill in plates that go around the AC pipes that seal the box under the plate in the engine compartment and inside the air induction box have become hard and brittle and now in pieces.
I have looked on the typical bronco aftermarket suppliers and had no luck...
Anyone have any suppliers that would have these...??

Thanks for you help.....
 

·
Premium Member
Joined
·
2,213 Posts
I've never seen these sold anywhere so you might have to either get them out of the junk yard and hope you can find some in better condition or fabricate your own.
 

·
Premium Member
Joined
·
149 Posts
Discussion Starter #3
I've never seen these sold anywhere so you might have to either get them out of the junk yard and hope you can find some in better condition or fabricate your own.
I was out in the shop today..and came across a truck rubber mud flap that will maybe work....;)
 
1 - 3 of 3 Posts
Top