Bronco Forum - Full Size Ford Bronco Forum banner
1 - 5 of 5 Posts

· Registered
'96 XLT, 5.0, E4OD, Electric 4X4, Automatic Hubs
Joined
·
293 Posts
Discussion Starter · #1 ·
These are 5 x 5 lug. 17 x 9. Wondering if these would work with adapters for our 96?



Sent from my iPhone using Tapatalk
 

· Registered
'96 XLT, 5.0, E4OD, Electric 4X4, Automatic Hubs
Joined
·
293 Posts
Discussion Starter · #3 ·
Thanks. I looked up the Specs, offset if -8 and backspacing is 4.69. The spacers would put them even further out?


Sent from my iPhone using Tapatalk
 

· Registered
'96 XLT, 5.0, E4OD, Electric 4X4, Automatic Hubs
Joined
·
293 Posts
Discussion Starter · #7 ·
I don’t think the wheel bore will clear your hub extension. I haven’t seen many 5x5 wheels that look big enough. May want to confirm on manufacturer’s website before committing.

Most 17” wheels seem to have little negative offset. I want to run a 17” but want an offset greater than -20 mm. They can be tough to find.
I would need to find the diameter of the bore hole? Looked around in their site and didn’t see it.


Sent from my iPhone using Tapatalk
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top